Can RFID tag be embed in a vacuum formed plastic item?

Not practical and also not economic.8g2GEENFC: A Global RFID tag, NFC tag, RFID Solution Provider

Firstly, vacuum formed plastic item normally is a single layer structure. Just as following illustration.8g2GEENFC: A Global RFID tag, NFC tag, RFID Solution Provider

plastic sheet heat for 40- 80 second until it is soft, normally the machine temperature already up to 180- 240 degree8g2GEENFC: A Global RFID tag, NFC tag, RFID Solution Provider
then evacuate to 0.1- 0.3 Mpa, formed for another 180 second, unit it hardened.8g2GEENFC: A Global RFID tag, NFC tag, RFID Solution Provider
this structure normally is single layer instead of multiple layer.8g2GEENFC: A Global RFID tag, NFC tag, RFID Solution Provider

8g2GEENFC: A Global RFID tag, NFC tag, RFID Solution Provider

Assuming place a RFID tag onto the mold is possible,8g2GEENFC: A Global RFID tag, NFC tag, RFID Solution Provider

a) shall withstand high temperature stress8g2GEENFC: A Global RFID tag, NFC tag, RFID Solution Provider

b) hard to assure the tag effectively embed into the plastic item, since it is just cold contact instead of fused together8g2GEENFC: A Global RFID tag, NFC tag, RFID Solution Provider

c) in addition, the vacuum plastic is normally very thin, if just for embed, then it is not economic.8g2GEENFC: A Global RFID tag, NFC tag, RFID Solution Provider

Normal procedure is by inject molding with high temperature resisted tag ( expensive, or just tagging on plastic surface. by using general purpose RFID tag.8g2GEENFC: A Global RFID tag, NFC tag, RFID Solution Provider

Regards,8g2GEENFC: A Global RFID tag, NFC tag, RFID Solution Provider

Michael Gan8g2GEENFC: A Global RFID tag, NFC tag, RFID Solution Provider
 8g2GEENFC: A Global RFID tag, NFC tag, RFID Solution Provider